Description
This evil Pro AC product is a wall-mounted charging station for all electrical vehicles. The charging station corresponds to the IEC 61851-1 standard. It can be attached to a stand on the floor or integrated into a housing set. The stand and housing set must be ordered separately. Installation possible inside and outside. The IP protection class is IP55. The IK protection type is IK10.
The operating temperature is between -30 ° C and 50 ° C. The storage temperature is between -40 ° C and 80 ° C. The output type is a connected 5 meter cable with a T2 connector with flap (T2S) at the end, installed at the top of the charging station. All contacts of the T2 connector are silvered to avoid overheating. The nominal output power is 11 kW. Provision three -phase (3P+N). The nominal charging current is 16 A at 380 V to 415 VAC at a frequency of 50 Hz to 60 Hz.
Using with TT, TN-S or TN-C-S-sterming system possible. Also IT compatible with an additional separator in the power supply. The charging station is easy to install and put into operation. Recommended for use at home, in vehicle fleets, on the street or at the workplace. The dimensions are (b) 317 mm x (h) 529 mm x (t) 183 mm. The product weighs 10 kg. The color is white (RAL 9003). Included are a built-in creep electricity protection with 6 MA creeping stream detection (RDC-DD) and a 30 MA fault electricity protection device (RCD) of type A-SI. For safety reasons, an MNX subsequent trigger is also integrated into the charging station. In addition, the EV ready requirements must be met. The charging station can be fed by a cable that runs from behind, top or bottom. To charge electric vehicles, access control is carried out by user authentication via an RFID or NFC ID.
The charging station can also be used freely. The start of the charging process can be delayed. During the loading time, the performance can be limited to ensure service contact and optimize the loading time of all charging stations based on the same power supply. Two Ethernet RJ45 inputs for LAN connection. The parameters are defined with the Esetup app via Bluetooth or Ecostruxure EV Charging Expert. The charging station can be managed in standalone or clustered architecture. The communication protocol OCCP 1.6 is used to connect to the surveillance device. Available services are charging data, diagnostics and charging management. The charging station has CE and EV Ready certification.
